Hortensus OP 014233 Manual De Instrucciones página 15

LITHIUM ELECTRIC CHAIN SAW
INSTALLATION INSTRUCTIONS
1. Charge the battery, the red light is on when charging and the green light is on when the battery is fully charged
2. Install the chain according to the operation drawing. Note: remove the battery pack during the installation and removal of the guide plate
3. After installation, start the machine with no load and observe that the machine runs normally
4.
1. Remove the sprocket cover
4. Adjust the tension of chain. (if the chain
saw is loose during use and cannot be
tightly attached to the guide bar. you can
also adjust here to tighten the chain)
TECHNICAL PARAMETER
2. Assemble the saw chain along the guide
bar
5. Tighten the nut with the wrench
3. Place the chain around the sprocket and
ensure guide bar line up the pin. Please
note!! The chain saw must be installed in
the correct direction
6. Insert the battery pack into the slot of bot-
tom.