Publicidad
Idiomas disponibles
Idiomas disponibles
500043
Parts sealed by the manufacturer or its agent should not be disassembled by the user. Do not
modify any part of the barbecue. Repairs and maintenance should only be carried out by an
accredited technician.
CONNECTING THE GAS CYLINDER TO THE GRILL
⚫ Before connection, ensure that nothing is obstructing the top of the cylinder, the regulator, burner
or burner ports. Spiders and insects can get into and obstruct the burner's supply tube orifice. An
obstructed burner could cause a fire under the appliance.
⚫ Clean the burner orifices using a stout pipe cleaner.
⚫ Secure the hose to the appliance using a spanner to tighten it on to the connection cable. When
replacing the hose, it should be fixed to the appliance and to the regulator using hose clips.
Disconnect the regulator from the cylinder (following the instructions supplied with the regulator)
when the barbecue is not in use.
The barbecue should be used in a well-ventilated area. Do not obstruct the flow if combustion air to
the burner when using the barbecue. THIS BARBECUE IS ONLY FOR OUTDOOR USE.
IDENTIFY ANY LEAKS BEFORE USE
NEVER LOOK FOR A LEAKS WITH A NAKED LIGHT, ALWAYS USE SOAPY WATER
TAKE GREAT CARE!!!
IF THERE IS A GAS LEAK, TURN OFF THE GAS SUPPLY IMMEDIATELY
LEAK TEST
⚫ Mix one part washing up liquid to three parts water to make 60 to 90 ml of leak finding solution.
⚫ Ensure that the control valve is closed.
⚫ Connect the regulator to the cylinder and the open/close valve to the burner. Ensure that
connections are correctly made and then open the gas inlet valve.
⚫ Spread the solution over the hose and all joins with a brush. If any bubbles appear, then there is
a leak, which must be repaired before the barbecue is used.
⚫ Test again, once the leak is repaired.
⚫ Close the gas inlet valve on the cylinder, when the test is complete.
⚫ If a leak is detected which cannot be repaired, do not attempt any other action but contact your
distributor.
LIGHTING INSTRUCTION FOR MAIN BURNER
1. Open the hood.
2. Turn all control knobs clockwise to the "OFF" position.
3. Connect the regulator to the gas cylinder. Open the gas inlet valve on the cylinder.
Using a soap solution to look for any gas leakage between all connections.
4. Push down the THIRD control knob and turn it anti-clockwise to the
It will light THIRD burner. Always turn the THIRD burner first.
5. Push and turn the LEFT & RIGHT side burner on by turning the control knob to "Max" position.
It will be light through the flame channel.
6. Adjust the heat by turning the control knobs to "Max" – "Min" position.
7. If the burners do not light, light it with a match in the orifice at the side of the appliance.
position,
Publicidad
