Publicidad
Idiomas disponibles
Idiomas disponibles
7.8
Adjustment of engine head (Fig. H)
Disconnect your gardening tool from the power supply.
▪
Press the angle adjustment, and adjust the engine head until it snaps into the desired
position.
After adjustment make sure that the angle adjustment buttons have returned
to their initial positions. Otherwise the tool cannot start.
Do not connect to power supply until assembly is complete, Failure to
comply could result in accidental starting and possible serious personal
injury.
8 CUTTING TIPS
▪
Assume a secure position, using two hands to hold the trimmer and switch on.
▪
Trim both sides of the hedge, starting at the bottom. This prevents cuttings falling into the
area yet to be cut.
▪
Pass the blade lightly through the surface of the hedge. Do not attempt to cut too deep.
▪
Trim the top of the hedge.
▪
For older hedges that require cutting back substantially, use pruning shears to cut the
thicker branches and then finish the job with the hedge trimmer.
▪
Never use the hedge trimmer without check the tightness of the bracket.
9 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power plug.
▪
Check your machine regularly before starting the work.
▪
Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
▪
After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
▪
Always keep the ventilation slots in motor housing clean
▪
Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine ,Finally, dry the motor housing carefully.
▪
Store the machine with the supplied protection cover(15)
▪
Only use original accessories and spare parts.
10 TECHNICAL DATA
Type
Voltage ~Frequency
Power input
Blade length
Cutting length
Cutting capacity
No load speed
Telescopic length
Copyright © 2024 VARO
POWXG2043
POWXG2043
230-240 V ~50 Hz
750 W
570 mm
510 mm
24mm
1500 /min
2.25 m to 2.74m
P a g e
| 7
EN
www.varo.com
Publicidad
