Descargar Imprimir esta página

Hilti DX 6 Manual De Instrucciones Original página 38

Ocultar thumbs Ver también para DX 6:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 88
▶ Use the loop to secure the tool tether to the product
as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure.
Check that the carabiner holds securely.
Comply with the operating instructions of the
Hilti tool tether.
5.3
Scaffold hook (accessory)
The Hilti scaffold hook (accessory) can be installed and used for hooking the product to a railing or a tool-
belt for a short time. To install the accessory, follow the installation instructions provided with the accessory.
There is a copy of the installation instructions at the end of these operating instructions.
The fastening tool must additionally be secured with the Hilti tool tether.
6
Operation
WARNING
Risk of injury by accidental triggering! A loaded fastening tool can be made ready to fire at any time.
Accidental triggering can endanger you and others.
▶ Always unload the fastening tool (cartridges and fasteners) whenever you interrupt work with the fastening
tool.
▶ Before all maintenance, cleaning and setup activities, always make sure that there are no cartridges and
no fasteners in the fastening tool.
WARNING
Hazard due to hot surfaces! The fastening tool can become hot in use.
▶ Wear protective gloves.
If resistance is unusually high when you insert the cartridge strip, check whether the cartridge strip is
compatible with this fastening tool.
Observe the safety instructions and warnings in these operating instructions and on the product.
Safety-related instructions for use
Illustration showing
example
30
English
Description
Do not press the nosepiece of the fastening tool against any part of the
body!
Pressing the nosepiece against a part of the body (a hand, for example) can
make the fastening tool ready to fire. As a result, there would be the risk of a
fastener being fired into a part of the body.
Do not pull back the magazine or other fastener guides by hand!
Pulling the magazine back by hand can make the fastening tool ready to fire. As
a result, there would be the risk of a fastener being fired into a part of the body.
2232121
*2232121*

Publicidad

loading

Este manual también es adecuado para:

Dx 6-f8Dx 6-f10Dx 6-mxDx 6 ie-lDx 6 ie-xl