Publicidad
Idiomas disponibles
Idiomas disponibles
Customization
©
• Long press the "
setup mode. The "
water temperature and volume, then press the "
machine will make a beep sound and the "
constantly. The intelligent memory setup is completed.
©
• Press the "
" button, the screen will display the stored water
temperature and water volume, press the safety lock button to unlock
(this step is not needed if ambient water is selected), the dispenser will
extract the customized water when you press the extraction button.
Changing water
When the "
" indicator of changing water ashes, the water in the raw
water tank needs to be changed, which will happen in the following
conditions:
• The water level of raw water tank is under or reaches the lowest water
level
• The TDS value of raw water is high
• The water in the raw water tank is not changed within 48 hours
To change the water, open the lid of the raw water tank, lift the raw water
tank upward and discard the residual waste water, ll the raw water tank
with tap water, place it back to the machine and close the lid properly.
Note: Do not add water into the raw water tank without discarding the
residual waste water.
Winter mode
• When the ambient temperature is lower than 10°C, winter mode can be
set.
• Long press the ambient button for 3 seconds, and then press the water
extraction button to extract 25°C ltered water. This operation is valid for
a single use.
" button for 3 seconds to enter the intelligent memory
©
" indicator will start ashing. Select the needed
©
" button again, the
©
" indicator will light up
08
3s
Publicidad
