Philips ADD6920 Manual Del Usuario página 8

First time use
• During rst time use, please check if any water leaks from or gathers
around the dispenser. If there is any strange noise, burnt smell or smoke
coming out from the product, please disconnect the power cord
immediately. Contact customer services if you nd any of the situations
above.
• For rst ime use, in order to ensure the best ltration performance, ll the
raw water tank and discard all ltered water when ltration is completed.
Repeat this until two tanks of tap water is ltered.
• For rst time use, when air passes the high-precision lter elements, micro bubbles are generated
causing the water in the pure water jug appears white and cloudy. This is a normal phenomenon.
• In order to avoid dry-heating and protect the machine, please extract some ambient water before
extracting hot water.
• To prevent excess steam, the local boiling point should be checked and adjusted; when ltration is
done and extracting water at 100°C for the rst time, boiled water will ow out from the nozzle
and the boiling point calibration will be completed automatically. This procedure will last for 60
seconds. A container with a volume not less than 500ml should be placed under the nozzle during
this procedure.
Note: Steam might be ejected during automatic boiling point calibration, please be aware of burn
hazards.
6. Usage instructions
Safety lock
• Safety lock and temperature memory enabled mode: The machine will
memorize the last selected water temperature preset, unlocking is required
before extraction of hot water; the machine will be locked with safety lock
automatically if no keys are pressed within 10 seconds; the safety lock and
temperature memory enabled mode is the default factory setting.
• Press the safety lock key for 10 seconds to disable the safety lock and
temperature memory. The temperature selection will return to "ambient"
after 10 seconds automatically. Press the safety lock key for 10 seconds to
enable the safety lock and temperature memory again.
05