Beta 1928P Instrucciones página 8

INSTRUCTIONS FOR USE
OPERATION MANUAL AND INSTRUCTIONS FOR AIR IMPACT WRENCH MANUFACTURED BY:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.
CAUTION
IT IS IMPORTANT TO READ THIS MANUAL THOROUGHLY BEFORE USING THE PNEUMATIC TOOL.
FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND OPERATING INSTRUCTIONS
MAY RESULT IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The air compact impact wrench can be used for the following purposes:
• assembling threaded connecting parts
• screwing and unscrewing by means of impact sockets
• the angle impact wrench can also be used in open places exposed to water and air
The air compact impact wrench must not be used for the following operations:
• the angle impact wrench must not be used with any hand sockets
• the angle impact wrench must not be used with any couplers or extensions, because these result in reduced power
of the impact wrench and increased risk of breakage
• the angle impact wrench must not be used in environments containing potentially explosive atmospheres
• the trigger must not be locked with adhesive tape or clamps.
WORK AREA SAFETY
• Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air hose
• While using the pneumatic tool for jobs performed high from the ground, take all necessary precautions, to eliminate
or minimize risk to other workers, following the accidental falling of any tools (for example, isolation of the work area
and proper signs).
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust or fumes.
Avoid contact with live equipment, because the pneumatic tool is not insulated, and contact with live parts can cause
electric shocks
Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other
people can cause you to lose control over the pneumatic tool.
PNEUMATIC TOOL SAFETY
• Do not point the air flow to yourself or other people. Compressed air can cause serious injury
• Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications
in terms of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause
damage and/or injury.
• Do not bend or tighten any hoses. Avoid using solvents and sharp edges. Keep the hoses away from heat, oil
and rotating parts.
Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed
air pipe. Raised rust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
8
EN