Descargar Imprimir esta página

Porter Cable PCL180CDK-2 Manual De Instrucciones página 9

Taladro/destornillador inalámbricos de 18v y 13 mm (1/2 pulg.)

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
Safety Warnings and Instructions: Drills
1. Hold the drill firmly with two hands, one hand on the handle, and the other
gripping the bottom around the battery area.
2. When attaching accessories in the drill chuck, hand tighten the keyless chuck
firmly.
WARNING:
Drill may stall (if overloaded or improperly used) causing a twist.
Always expect the stall. Grip the drill firmly with tw hands to control the twisting action
and prevent loss of control which could cause personal injury. If a stall does occur,
release the trigger immediately and determine the reason for the stall before re-starting.
Installing and Removing the Battery Pack From the Tool
CAUTION:
Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack
into tool until an audible click is heard as shown in
figure C.
TO REMOVE BATTERY PACK: Depress the
battery release button as shown in figure D and
pull battery pack out of tool.
Operating Instructions
Trigger Switch & Forward/Reverse
The drill is turned ON and OFF by pulling and
Button - Figure E
releasing the trigger switch (1) shown in
figure E. The farther the trigger is depressed,
the higher the speed of the drill.
A forward/reverse control button (2) determines
the direction of the tool and also serves as a
lock off button.
To select forward rotation, release the trigger switch and depress the
forward/reverse control button on the right side of the tool.
To select reverse, depress the forward/reverse
control button on the left side of the tool.
The center position of the control button locks
the tool in the off position. When changing the
position of the control button, be sure the
trigger is released.
When drill is activated by pulling the trigger switch
LED Work Light
(1), the integrated LED work light (9) will
automatically illuminate the work area. NOTE: The
work light is for lighting the immediate work
surface and is not intended to be used as a
flashlight.
C
D
E
9
2
1

Publicidad

loading

Este manual también es adecuado para:

Pcl180cdPcl180cdk-2-caPcl180cd-ca