WARNING:
rope around your hand.
5. Set the choke control in the operation position.
6. If the engine starts, push the throttle trigger lightly
and let the engine run 60 seconds to become warm.
If the engine does not start, pull the starter rope
handle until the engine starts. Then push the throttle
trigger lightly and let the engine run 60 seconds to
become warm.
CAUTION:
rope to full extension and do not let
go of the starter rope handle. This can
cause damage to the product. Release
the starter rope slowly.
To start a warm engine
1. Push the air purge bulb 10 times.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
Maintenance schedule
Maintenance
Clean the external surface.
Clean the air filter. Replace if it is necessary.
Examine the function of the throttle trigger lock and the throttle.
Examine the stop switch.
Examine the locknut.
Examine for fuel leaks.
Apply grease to the two-piece shaft.
Examine the starter rope handle and the starter rope.
Examine the bevel gear grease.
Clean the external surface of the spark plug. Remove the spark plug and meas-
ure the electrode gap. Adjust the electrode gap or replace the spark plug.
Clean the cooling system.
Clean or replace the spark arrestor screen on the muffler.
Clean the external surface of the carburetor and the area around it.
Examine the fuel filter for contamination.
2554 - 001 - 19.07.2024
Do not twist the starter
Do not pull the starter
Maintenance
Before you do
2. Pull the starter rope until the engine starts.
To stop the product
•
Push the stop switch to stop the engine.
Note:
The stop switch automatically goes back to its
initial position.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to .
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
11