Publicidad
Idiomas disponibles
Idiomas disponibles
EVERY SIX MONTHS
•
Hold the beard trimmer in one hand so that the blades are at the top, and the front of the body is
facing you.
•
Brush the accumulated hair from the blades.
•
To replace the blade, make sure the blade is aligned and the grooves on the blade cartridge
match up with slots in the housings.
•
Push the blade into the housing until it snaps into place.
PRODUCT DISPOSAL
When this product reaches the end of its useful life, the batteries must be removed and be recycled
or disposed of properly in accordance with your state and local requirements. If this is not required
by law, you may elect to dispose of the product with the batteries.
CAUTION! Do not put in fire or mutilate your batteries when disposing as they may burst and
release toxic materials. Do not short circuit as it may cause burns. Dispose of properly in accordance
with your local and state requirements.
To remove the rechargeable battery:
1.
Remove the comb and cutter assembly.
2. Use a screwdriver to pry out the holder plate under the trimmer carefully.
3. Use a screwdriver to pry the two side panels carefully.
4. Remove the 4 screws from the housing.
5.
Using a screwdriver carefully pry apart the top and bottom housing.
6. Unscrew the 2 screws on the circuit board.
7.
Remove the upper circuit board.
8. Disconnect the battery from the low circuit board.
PRECISION TRIMMER, AND ROTARY TRIMMER
INSERTING BATTERIES
•
Your trimmer requires 1 'AAA' alkaline battery (included).
•
Ensure the product is switched off.
•
To open the battery compartment, turn the base of the unit approximately 1cm counter-
clockwise and pull it off.
•
Insert the battery into the unit, positive end first.
•
Replace the base and turn it 1cm clockwise to lock it into place.
Note: Your trimmer will not work if the batteries are inserted incorrectly.
INSTRUCTIONS FOR USE
Note: Do not apply excessive pressure as this damages the trimmer head and may cause skin injury.
TO REMOVE HAIR FROM NOSE
•
Follow the diagrams on page 3 and attach the rotary head to the detail trimmer handle.
•
Insert trimmer's cutting unit gently into the nostril.
7
Publicidad
