Kesser KKA-2001 Manual De Instrucciones página 39

Surge protector
In the event of a power failure, it takes 3 minutes for the compressor to restart to
protect the compressor.
Self-evaporating system
The self-evaporating system uses the collected water to cool the condenser coils for
more efficient performance. It is not necessary to empty the waste water tank in
cooling mode, except in drying mode and at high humidity. The condensation water
evaporates at the condenser and is discharged via the exhaust air hose.
For continuous operation or unattended operation when drying, please connect the
attached drain hose to the device. Condensation water can automatically flow into
a bucket or drain by gravity.
Turn off the device before

operation.
Remove the plug of the water

outlet opening and store in a safe
place.
Connect the drain hose safely and

properly and make sure it is not
kinked and clogged.
Place the hose outlet over a drain

or bucket and make sure the water
can escape unhindered from the
device.
Do not submerse the end of the

hose in water. Otherwise, there
may be an air barrier in the hose.
To avoid spillage of water:

If the negative pressure of the condensate tray is large, tilt the drain

hose downwards towards the ground. It is appropriate that the
degree of inclination exceeds 20 degrees.
Align the hose straight to avoid a trap in the hose.

Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
39
Remove the rubber sealing
plug.
Continuous drain pants
(Inner diameter =
www.eshopping.de
16mm)