Publicidad
Idiomas disponibles
Idiomas disponibles
FLOOR CLEANING
CONNECTION OF THE BATTERIES TO THE MACHINE
Plug in the batteries connector (1) to the machine connector (2),
placed in the rear part of the machine.
RECOVERY TANK
Verify that the squeegee hose coupling (1) is correctly inserted
into its seat and that the drain hose plug (2) is closed. The recov-
ery tank is provided with a cover (3) that seals itself thanks to the
vacuum created by the suction motor during its use.
DETERGENT SOLUTION TANK
The solution tank is provided with an inspection opening. This per-
mits to cleaning of the exit point of the detergent solution. Be sure
that the cap is tightened after cleaning.
The capacity of the detergent solution tank is indicated in the tech-
nical data.
Open the screw plug placed in the rear right part of the machine
and fill the detergent solution tank with clean water at a maxi-
mum temperature of 122°F (50°C). Add the liquid detergent in the
percentage and conditions recommended by the manufacturer. To
avoid excessive foam, which could cause problems to the vacuum
motor, use the minimum percentage of detergent recommended.
On the side of the machine there is a level hose that permits the
operator to easily see the solution level inside the tank both during
the filling of the tank and during operations.
Screw down the plug of the solution tank.
Always use low foam detergent. To avoid foaming , before starting
working operation, add a small amount of anti-foam product into the
recovery tank.
Never use pure acid.
3S SYSTEM "SOLUTION SAVING SYSTEM" (OPTIONAL)
The system is composed
of a separate line parallel
to the main solution line. It
can be enabled or disabled
directly from the instrument
panel by holding for about
3 seconds the push button
(1). When the system is
on, the 3S symbol appears
on the display as shown in
the picture.
Once activated you can proceed with the cleaning.
12
Publicidad
