Hayward Pool AquaRite + Manual Del Usuario página 33

A ssigning speeds
Whatever the filtration mode (Manual, Automatic, Smart, Heating or Intelligent), one of the three operating speeds (V1, V2 or
V3) can be selected, thus providing a high degree of flexibility for setting and adjusting the water flow according to the equipment.
The device will first have to be configured to take the variable-speed pump into account (see the section entitled "Setting the pump
type").
The speed assigned to the "antifreeze" mode is V2.
Note: We should point out that the speed of all pool devices requiring a minimum water flow that is appropriate to their correct
operation must be set manually before being stored in the memory and used by the AquaRite + (heat pump, chlorinator, etc.). See
the variable-speed pump instructions for setting all the parameters related to its operation and safety.
Connecting the Wifi option (Optional)
Plug the Wifi module connector into the RF / WIFI connector on the AquaRite + card.
Installing the screen wall-mounting kit (not supplied)
Remove the screen from the box and unplug it.
Plug the extension connector into the DISPLAY connector on the AquaRite + card.
Plug the other end of the extension into the screen after first passing the cable through the wall bracket.
Fit the cover (supplied) over the front of the AquaRite + to replace the screen.
USE ONLY GENUINE REPLACEMENT PARTS
Page 11 of 21 AquaRite + Rev. B