Clutch Torque Setting; Control Panel - Panasonic EY7549 Manual De Instrucciones

Drill Driver Operation
Select Drill driver High or Low mode
with the mode select switch.
• Switch to the Impact or Drill driver
High/Low position only when the tool
has completely stopped rotating.
Damage may be caused if the tool is
rotating.
Drill driver Low mode
Drill driver High mode

Clutch Torque Setting

Adjust the torque to one of the 21
clutch set tings or " " position.
CAUTION
:
Test the setting before actual opera-
tion.
Set the scale at this mark (
How to Use the Belt Hook
WARNING!
• Be sure to attach the belt hook
securely to the main unit with the
screw firmly fastened. When the belt
hook is not firmly attached to the main
unit, the hook may disconnect and the
main unit may fall.
This may result in an accident or
injury.
• Periodically check screw for tightness.
If found to be loose, tighten firmly.
• Be sure to attach the belt hook firmly
and securely onto a waist belt or other
belt. Pay attention that the unit does not
slip off the belt. This may result in an
accident or injury.
• When the main unit is held by the
belt hook, avoid jumping or running
with it. Doing so may cause the hook
to slip and the main unit may fall.
This may result in an accident or
injury.
• When the belt hook is not used, be
sure to return it to the storing posi-
tion. The belt hook may catch on
something.
This may result in an accident or
injury.
• When the unit is hooked onto the
waist belt by the belt hook, do not
attach driver bits to the unit. A sharp
edge object, such as a drill bit, may
cause injury or an accident.
To Change the Belt Hook
Location Side
The belt hook can be attached to either
side of the unit.
1. Removing the hook
(1) Remove the nut.
(2) Draw out the hook.
).
2. Attaching the hook to the other side
(1) Insert the hook in the other side.
(2) Tighten the nut fully so that it

Control Panel

(1)
(1) LED light
does not adversely affect the perfor-
mance of the tool during use or its bat-
tery capacity.
- 10 -
1
2
securely fastened.
Before the use of LED
light, always pull the power
switch once.
Press
button.
The light illuminates with
very low current, and it
1
2
(3)
(2)
the LED light