Door Closing And Door Alignment; Refrigerator Use; Using The Controls - Kenmore 596.7931 Manual De Uso Y Cuidado

Door Closing and Door Alignment

The base grille covers the leveling screws and roller assemblies located at
the bottom of the refrigerator cabinet below the freezer door or drawer.
Before making adjustments, remove the base grille and move the
refrigerator to its final location.
1. Remove the two screws fastening the base grille to the cabinet, and
set the screws aside. Grasp the grille and pull it toward you.
2. Move the refrigerator to its final location.
NOTE: To allow the refrigerator to roll easier, raise the leveling legs off
the floor by turning the leveling screws counterclockwise. The front
rollers will be touching the floor.
3. So the doors will close easier, use a ¹⁄₄" hex driver to turn both leveling
screws clockwise. This will raise the front of the refrigerator tilting it
slightly downward to the rear. Turn both leveling screws the same
amount.
NOTE: Having someone push against the top of the refrigerator takes
some weight off the leveling screws. This makes it easier to turn the
screws.
A. Leveling screw
B. Front roller
4. Open and close the doors to make sure they close as easily as you like.
If not, increase the tilt by turning both leveling screws clockwise. It may
take several turns of the leveling screw to allow the doors to close
easier.
12
¹⁄₄"
A
B
5. Check for door alignment. If one door is lower than the other, adjust
the leveling screw, on the lower side of the refrigerator. Using a ¹⁄₄" hex
driver, turn the screw clockwise to raise that side of the refrigerator
until the doors are aligned. It may take several turns of the leveling
screw to raise the refrigerator.
NOTE: Having someone push against the top of the refrigerator takes
some weight off the leveling screws. This makes it easier to turn the
screws.
6. Make sure the refrigerator is steady. If the refrigerator seems unsteady
or rolls forward when the door or drawer is opened, adjust the leveling
screws. Using a ¹⁄₄" hex driver, turn the leveling screw on each side
clockwise until the rollers are up and the leveling feet are firmly
against the floor.
7. Replace the base grille by aligning the holes in the grille with the holes
in the cabinet and fasten using the screws removed in Step 1.

REFRIGERATOR USE

Using the Controls

The temperature controls are located at the top front of the refrigerator or
freezer compartments.
Temperature Controls
For your convenience, the temperature controls are preset at the factory.
When you first install your refrigerator, make sure the controls are still set
to the recommended setting as shown.
Recommended Setting "4"
IMPORTANT:
The recommended setting should be correct for normal household
■
refrigerator use. The controls are set correctly when milk or juice is as
cold as you like and when ice cream is firm.
¹⁄₄"