Wall Mounting - switel COIP200B Manual De Instrucciones

Installation
Insert the memory card and switch on the camera
1. Slide lock in direction of arrow and open cover.
2. Insert micro SD card (not supplied / up to 128 GB, FAT
formatted) into the card slot "TF" (contacts face down).
To remove the micro SD card push it a little way into the
slot. ATTENTION! It is then ejected with spring pressure.
3. To switch the camera on, the switch must be set to the ON
position.
4. Close the cover and make sure that the lock closes
correctly.
Note: The battery must be charged before commissioning. Make sure that the switch is
in the ON position and plug the included micro USB cable into the camera and the
charger. Use a standard USB charger with 5V and at least 2A (10 watt type).
The camera shows a green, flashing LED when switched on (ON).
If the battery is completely discharged, it may take some time before the LED is
switched on. Charge the battery for at least 12 hours when you use the camera for the
first time.

Wall mounting

1. Attach the bracket to a wall. When drilling, make sure that you do not damage pipe or
power lines.
2. Place the camera (magnetic surface) on the bracket and align it.
GB
9