Getting Started; Preparing The Remote; Replacing The Battery In The Remote - Sony NAS-CZ1 Manual De Instrucciones

Getting Started

Preparing the remote

Pull out the insulating sheet to allow power
to flow from the battery.
The remote already contains a battery.
Replacing the battery in the
remote
1
Slide out and remove the battery case.
2
Insert a new lithium battery CR2025 with the
+ side facing up.
3
Slide the battery case back in.
Note
If you do not use the remote for a long period of time,
remove the battery to avoid possible damage from
battery leakage and corrosion.
10 GB
A lithium battery CR2025
Notes on lithium battery
• Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
• Wipe the battery with a dry cloth to assure a good
contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
Tip
When the remote can no longer operate the system,
replace the battery with a new one.
WARNING
Battery may explode if you mistreated.
Do not recharge, disassemble or dispose of in fire.