DeWalt DWD450 Manual De Instrucciones página 7

FIG. 3
FORWARD REVERSE
SLIP CLUTCH
The DWD450 and DWD460 are each equipped with a slip clutch.
The clutch is active when the low speed (1)is selected. When the bit
or cutter bites into the workpiece, the clutch will slip and a ratcheting
sound will be heard. Release the trigger. Continued clutching of the
tool will reduce tile life of this feature.
E-CLUTCH
TM
(DWD460)
The DWD460 is equipped with E-Clutch
TM.
This feature senses the
motion of the tool and reduces the motor torque to a manageable
level if necessary. The E-Clutch
TM
indicator (G) will illuminate to indicate
status.
INDICATOR DIAGNOSIS SOLUTION
Follow all warnings and
OFF Tool is functioning instructions when
normally operating the tool.
With the tool properly
supported, release trigger.
E-Clutch
TM
has been The tool will function
SOLID
activated (ENGAGED) normally when the trigger
is depressed again and the
indicator liqht will go out
INDICATOR DIAGNOSIS SOLUTION
E-Clutch
TM
is Take the tool to an
FLASHING malfunctioning authorized DEiWALT
(SERVICE) repair aqent.
NOTE: If tool power is insufficient for normal drilling and LED does not
flash take tool to authorized DEWALT repair center.
Bail Handle (Fig. 4)
A bail handle is provided for carrying the tool and for use as an
additional handle. Assemble the bail handle in one of the positions
shown in Figure 4. When changing the location of the bail handle from
one position to the other, completely remove the two bail handle bolts
(E)securing it. Flip the handle over and reinstall.
FIG. 4
J E
Side Handle (Fig. 5)
_WARNING: To reduce the risk of personal injury, always operate
the tool with the side handle properly installed and tightened. Failure
to do so may result in the side handle slipping during tool operation
and subsequent loss of control Hold tool with both hands to
maximize control