Kenwood KFC-W3000L Manual De Instrucciones página 4

Connection
Caution:
Before wiring, be sure to remove the wire from the negative terminal of the battery. After completing all wiring, check the correct wirings
again. After checking, connect the wire from the negative terminal of the battery.
Woofer unit
(KFC-W3000L)
1 Connect the POWER jack of the Control box 1
and amplifier using DC cable 3 .
(If there is no power control terminal in the ampli-
fier, connect to the accessory (ACC) line.)
2 Connect the LINK jack of the Control box 1 and
LINK IN jack of the Woofer unit using Link cable 4 .
(A modular cable (commercially available) cannot
be used.)
3 Connect the amplifier and the Woofer unit with
speaker cords.
Connecting the remote control unit Connecting the remote control unit
2 Remote control
Note:
The illumination function cannot be used when the Remote control 2 is not connected. Be sure to connect the Remote control 2 to the
Control box 1 .
4
English
Speaker cord (Commercially available)
1 Control box
4 Link cable
Connect with the lock part of
LINK jack facing down.
1 Control box
Amplifier is not included in this product.
Please use a commercially available amplifier.
Fuse (2A)
3 DC cable
BATT: Yellow
GND: Black
P.CONT: Blue/White
Battery
Notes:
• The illumination function cannot be used if the Link cable 4 is
connected erroneously to the LINK OUT jack of the Woofer unit.
Be sure to connect the Link cable 4 to the LINK IN jack.
• Do not plug or unplug the connection cables without switching
the power off. Otherwise, malfunction may result.
Connect the Remote control 2 to the REMOTE termi-
nal of the Control box 1 .
Amplifier
If there is no
power control
terminal in the am-
plifier, connect the
blue/white wire to
the accessory line
(ignition key
switch ACC posi-
tion line).
Center unit