Kenwood KFC-W3000L Manual De Instrucciones página 6

Installation
Fixing the Subwoofer Fixing the Subwoofer
1 Place the supplied template on the panel and
then mark the hole positions.
2 Cut open a large hole and make screw holes.
3 Peel off the covering sheet from the spacer, and
attach the spacer on the back of the speaker
flange so that the flange is completely covered.
Fixing the Control box Fixing the Control box
7 Screw (ø 4 x 16) x 2
REMOTE
6
English
6 Screw (ø 4 x 35) x 8
LINK POWER
How to use the Cord bush How to use the Cord bush
When you use a box for Woofer, use the attached Cord bush.
1 On the Woofer box, make a hole (ø 17.5) for fitting
the Cord bush 5 .
2 Pass the Link cable 4 through the hole on the
Woofer box.
3 Attach the Cord bush 5 on an appropriate posi-
tion of the Link cable 4 .
4 Push the Cord bush 5 into the hole on the Woofer
box.
Notes:
• Fit the Cord bush 5 firmly because clearance will lead to air
leak.
• Be careful not to pinch the Link cable 4 with the surface of the
Cord bush 5 .
Technical specifications Technical specifications
SYMBOL
Nominal impedance Z
DC resistance Revc
Voice coil inductance Levc
Piston area Sd
Force factor BL
Volume acoustic compliance Vas
Moving mass Mms
Resonance frequency Fs
Mechanical Q factor Qms
Electrical Q factor Qes
Total Q factor Qts
Peak power
Peak excursion Xmax
Displacement
Mounting depth
Weight of magnet
Voice coil diameter
4 Link cable
ø 17.5
5 Cord bush
UNIT VALUE
Ω 4
Ω 3.4
mH 0.56
sq.m 0.052
T.m 9.53
Liters 97.75
cu.ft 3.45
g 105.6
Hz 30.9
9.59
0.77
0.71
W 800
mm 4.6
cc 5,190
cu.ft 0.183
mm (in.) 150 (5-7/8)
g (oz) 740 (26.1)
mm (in.) 50 (1-15/16)