Audio Adjustments; Introduction Of Audio Adjustments; Using Balance Adjustment - Pioneer DEH-P65BT Manual De Instrucciones

Operating this unit

Audio Adjustments

Introduction of audio adjustments

1 Audio display
Shows the audio adjustment status.
2 SW indicator
Shows when the subwoofer output is turned
on.
3 BASS indicator
Shows when the bass boost is in effect.
4 Loudness indicator
Appears in the display when loudness is
turned on.
5 FIE indicator
Shows when the front image enhancer is
turned on.
1 Press MULTI-CONTROL to display the
main menu.
FUNCTION or AUDIO appears on the display.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option; press to se-
lect.
The audio function name appears on the dis-
play.
3 Turn MULTI-CONTROL to select the
audio function.
Turn MULTI-CONTROL to switch between the
audio functions in the following order:
FADER (balance adjustment)—P.EQ (equali-
zer)—EQ (equalizer curve adjustment)—
EQ-LOW 80HZ Q1W (equalizer curve fine ad-
justment)—LOUDNESS (loudness)—SUB W1
(subwoofer on/off setting)—SUB W2 (subwoo-
fer setting)—HPF (high pass filter)—
BASS BOOST (bass boost)—FIE (front image
enhancer)—SLA (source level adjustment)
# When the subwoofer controller setting is
PREOUT:FULL, you cannot switch to SUB W1
(subwoofer on/off setting). (Refer to page 43.)
# When the rear output setting is
REAR SP:SUB W, you cannot select FIE.
# When the F.I.E. function is on, you cannot se-
lect HPF.
# When the high pass filter is on, you cannot se-
lect FIE.
# You can select the SUB W2 only when sub-
woofer output is turned on in SUB W1.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
# If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.

Using balance adjustment

You can change the fader/balance setting so
that it can provide you an ideal listening envir-
onment in all occupied seats.
1 Use MULTI-CONTROL to select FADER.
# If the balance setting has been previously ad-
justed, BALANCE will be displayed.
2 Push MULTI-CONTROL up or down to
adjust front/rear speaker balance.
Each time MULTI-CONTROL is pushed up or
down, the front/rear speaker balance moves
towards the front or rear.
F 15 to R 15 is displayed as the front/rear
speaker balance moves from front to rear.
# F/R 0 is the proper setting when only two
speakers are used.
# When the rear output setting is
REAR SP:SUB W, you cannot adjust front/rear
speaker balance. Refer to Setting the rear output
and subwoofer controller on page 43.
3 Push MULTI-CONTROL left or right to
adjust left/right speaker balance.
Each time MULTI-CONTROL is pushed left or
right, the left/right speaker balance moves to-
wards the left or right.
L 15 to R 15 is displayed as the left/right
speaker balance moves from left to right.
Section
02
37
En