stayer SCR315W Manual De Instrucciones página 50

1 7 . P r o t e c t o r s ; s a f e t y a n d
adjustment
Mechanical protection equipment
C
IMAGE
1. General protection carter 21.
2. Pendular protection cap 6.
3. Stationary lower guard 49.
4. Movable guard of upper table 43.
Electric protection equipment
1. Class I electric isolation with connection of metal
parts of the machine to the ground protection
circuit of the officially approved electric
installation.
2. Protection module that cuts the electric supply to
avoid fortuitous starts in a machine after
reestablishment after a blackout.
18.General safety instructions
¡WARNING!
When using electric tools, basic safety precautions
should always be followed to avoid hazards of fire,
electroshock and personal injuries including the
following:
The general safety instructions are in a separate
manual included in the documentation of the
equipment.
Carefully read these instructions before using this
product and keep them.
1 9 . R e g u l a r
maintenance and lubricating
Cleaning
The machine is to be cleans starting with a fine
brush or paintbrush to dislodge remainders of
sawdust, and a soft cloth. If pressurized air is
available, it is recommendable to complete
cleaning of the tool machine using the air pistol.
ENGLISH
48
c l e a n i n g ,
48
Maintenance
Every 2,000 hours of use or each two years the
electric tool must be sent to the official technical
service for maintenance and complete inspection.
Except for the operation of replacing brushes, the
machine does not require any specific maintenance
to be carried out by the user. Keep the machine
clean and use it correctly. Regularly check the
correct condition of the adjustments as authorized
to a sufficiently-trained user. In case of any failure or
doubt, contact our technical service.
Lubrication
The machine does not require any specific
lubrication to be carried out by the user. The specific
lubrication of the electric tool will be made on the
occasion of the periodical servicing inspections at
the official technical service.
2 0 . R e p a i r s e r v i c e s b y t h e
manufacturer or commercial
agent
Stayer Ibérica S.A. Área Empresarial de Andalucía
- Sector 1, Calle Sierra de Cazorla nº7. CP:28320.
Pinto (Madrid) Spain.
21.List of parts replaceable the
user
C E
IMAGES
1. Cutting disk 16.
2. Movable guard of the upper table 42.
3. Guides for adjusting the cutting depth of the
lower table 9.
4. Guides for adjusting the cutting depth of the
upper table 44.
22.Special tools that might be
required
The necessary tools are standard one or are
included with the machine's complements.