Remote Control Unit; Battery Installation; Battery Replacement; Wall Mounting - Teac SP-X2i Manual Del Usuario

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
remote sensor on the Dock.
< Even if the remote control unit is operated within the effective
range (16 ft./5 m), remote control operation may be
impossible if there are any obstacles between the unit and the
remote control.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may also
operate incorrectly.

Battery Installation

1
2
3
1. Remove the battery compartment cover.
2. Put in the lithium battery (CR2032, 3V).
3. Close the cover.

Battery Replacement

If the distance required between the remote control unit and
the Dock decreases, the battery is exhausted. In this case,
replace the battery with a new one.
Precautions concerning batteries
Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.

Wall Mounting

You can mount the left and right speakers on a wall.
Precautions
< The length of the speaker cables is about 10 feet (3 m). Do
not attempt to mount the speakers too far from the
subwoofer.
< Drill holes into solid wall support, such as wooden frame or
concrete wall.
< TEAC supplies these brackets as a convenience to the product
owner. Consult your local building codes and exercise all
necessary caution when mounting these brackets. If you are
unsure how to use the supplied brackets, consult with a local
tradesmen or building supply expert.
To hook on the wall
1. Use the supplied guide sheet to mark the exact drilling
points on the wall.
2. Secure the wall mount adapters on the wall using the
supplied screws.
< As a convenience, a set of tapered plastic anchors is supplied.
If you chose to use these anchors, drill a pilot hole using a 6
mm drill bit then tap the anchor into the pilot hole.
Only use these anchors if they are appropriate for the
materials onto which the unit is to be mounted. Consult your
local hardware store if you are uncertain.
3. Before going on, connect the speakers and the
subwoofer using the supplied speaker cables (see page
6-7).
4. Carefully hang the speakers onto the hooks.
Note:
Ensure that the speaker locks onto the hooks and that the
wall is strong enough to support the weight before removing
your hands.
Wall
Hook
Adapter
Speaker
5