Teac SP-X2i Manual Del Usuario página 7

A SPEAKERS
Connect the speakers using the supplied speaker cables.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
< If not using the included speakers, make sure the speakers
you use are at least 4 Ω impedance.
< Do not connect anything other than speakers to these
terminals.
B
Dock
Connect the Dock to the "TO DOCK" port, and fasten the
cable with the clip.
< Securely insert the plug in the direction as figured.
C AUX 1 IN jack
You can connect a portable audio player to this jack.
Connect the LINE OUT or PHONES jack (audio output jack)
of the player using the supplied stereo mini plug cable.
When using the PHONES jack of your mini player, you must
adjust the volume of the mini-player or you may hear no
sound from your SP-X2i.
D
AUX 2 IN jacks
Analog 2-channel audio signal is input from these jacks.
Connect a DVD/CD player, cassette tape deck etc. to these
jacks using a commercially-available RCA cable.
Make sure to connect:
white plug q white jack (L: left channel)
red plug q red jack (R: right channel)
E
AC Power Cord
Be sure to connect the power cord to an AC outlet which
supplies the correct voltage.
Hold the power plug when plugging or unplugging the
power cord. Never pull or yank on the power cord.
F POWER switch of the Subwoofer
Use this switch to turn the system on or off.
G
S-VIDEO OUT terminal
This terminal outputs video signal from iPod.
Use an S-Video cable to connect the Dock to the S-Video
input of a suitably equipped television or monitor. Use this
connection in preference to a composite video connection.
H VIDEO OUT terminal
This terminal outputs video signal from iPod.
Use an RCA (pin) video cable to connect the Dock to the
composite video connector of a television or monitor.
7