3M PELTOR TEP-100 Instrucciones De Uso página 7

Operating 3M PELTOR Tactical Earplug, TEP-100
1. Power On: Press and hold the Power/Volume button (Fig.A:1) for two seconds. You may
release the button when you hear a tone. The earpiece should now be on and in the normal
volume setting. Repeat this process for the other earpiece.
Note: When the earpiece is turned on and properly fitted in your ear, sound entering your ear
should not sound distant, faint, or muffled. If it does, make sure the device is turned on.
2. To change between the two listening levels, quickly press and release the Power/Volume
button to toggle between the "normal" and "high" volume settings. A short, high pitch tone
will be heard when moving to the "high" volume setting and a short, low pitch tone will
be heard when moving to the "normal" volume setting. When using the "normal"volume
setting, sounds entering the ear canal should be about the same volume as if the user
was not wearing hearing protection. The "high" volume setting should give the user a
sense of amplification.
3. Automatic shutoff: To conserve battery power, the device has an automatic shutoff
timer. The 3M PELTOR Tactical Earplug, TEP-100 will automatically shutoff when the
Power/Volume button has not been pressed for 2 hours. During the last 60 seconds before
shutoff, a warning tone will sound every 10 seconds indicating the automatic shutoff timer.
To reset the automatic shutoff timer, the user should press the Power/Volume button.
4. Power Off: Press and hold the Power/Volume button for two seconds, until a double beep
is heard. Then the button can be released and the earpiece is powered off. Repeat this
process for the other earpiece.
Note: When the earpiece is powered off, and the devices are in the ear canals and properly
fitted, noise reduction is similar to having conventional earplugs in your ears.
Fig. A
7
A:1
A:2
A:3
A:5
A:4