Lcd Display Characters - PRESIDENT MC 6800 DSC Manual Del Usuario

9. Channel 16 (16)
It will automatically select channel 16 on high transmission power when pressed. Any func-
tion active (Dual watch, scanning etc.) will be cancelled.
10. and 12. Scan (SCN)/Memory scan (M.SCN)
This function scans through each channel sequentially until a signal above the squelch level
set is detected. Once the signal ends or drops below the squelch level set, the radio will
continue scanning. Press "SCN" or "M.SCN" to enter scan mode, the LCD will show "FS"(Full
scan) or "MS"(Memory scan) on the bottom right of the LCD screen.
Note that the radio will not transmit, nor will alternate channels be able to be selected while in
scan mode. To restore normal operation, either press "SCN" or "CLR" again. Press "16" the
radio will restore normal operation and will select channel 16.
The memory scan operates in the same way as the scan, except that it will only scan chan-
nels that have been entered into the scan memory. If no channel has been entered into the
memory then this function will not be available.
11. Dual watch (DW)
Dual watch enables the radio to scan between the selected channel and priority channel
(CH16), To activate dual watch mode select the channel and press "DW" key, the "DW"
legend will be displayed on the bottom right of the LCD.
Note that the radio will not transmit, nor will alternate channels be able to be selected while in
dual watch mode. To restore normal operation, either press "DW", "CLR". Press"16" the radio
will restore normal operation and will select channel 16.
13. Backlighting (DIM)
There are four steps of brightness levels. When power of the Radio is switched on, the
backlighting is brightest.
The LCD backlighting is controlled by pressing "DIM" button.
14. RF High or Low Output Power (H/L)
This "H/L" button operates as a toggle switching between 1W and 25W.
When RF output power is set at 1W or 25W, the "Lo" or "Hi" symbol will show at bottom right
of the LCD screen.
Note that some channels are restricted to 1W transmit power. The radio is programmed to
switch to low power automatically when one of these channels is selected.
15. Channel Memory Function (M+)
The function of this key will add the currently selected channel into the scan memory. Press
the "M+" key the LCD display will show "M" on the bottom right of the LCD display, indicating
that the channel has been entered into the scan memory. Press the "M+" key again if the
channel is already in the memory, the "M" will be deleted indicating that the channel is not a
memory scan channels.
16. Distress call button with a safety guard

3. LCD DISPLAY CHARACTERS

The meaning of characters on the button right of the LCD display are as follows:
M Indicate the displayed channel is the memory-scanning channel
D Indicates the displayed channel is duplex channel
S Indicates the dis played channel is simplex channel
DW Indicates Dual watch scanning operation
FS Scans every channels of current channel list
37