♦
Take the cut length add-on
♦
If necessary, you can wash the cut length add-ons
♦
Always dry the cut length add-ons
♦
To remove the trimmer block
against the shaving head teeth from the front.
♦
Use the cleaning brush supplied to remove any residual hair from the trimmer
block
♦
Once you have completed cleaning, plug the trimmer block plug-in tab
into the mounting opening in the shaving head holder (see Fig. E).
♦
Allow the trimmer block
(see Fig. F).
NOTE
►
In order to reduce friction, occasionally apply a couple of drops of scissor
oil (accessory) between the blades, and then distribute it evenly. You can
also use any acid-free oil (e.g. sewing machine oil). Wipe any access oil
off with a cloth.
Disposal
Disposal of the appliance
Never dispose of the appliance in normal household waste.
This product is subject to the provisions of European Directive
2012/19/EU (Waste Electrical and Electronic Equipment).
Dispose of the appliance through an approved disposal centre or at your com-
munity waste facility. Please observe the currently applicable regulations. Please
contact your waste disposal centre should you be in any doubt.
NOTE
►
Before disposing of the appliance it is essential to remove the battery fi rst.
►
To do this, dismantle the appliance completely and remove the recharge-
able batteries from the PCB.
Disposal of batteries
Used batteries may not be disposed of in household waste. Every consumer is
legally obliged to dispose of batteries at a collection site of his or her community /
city district or at a retail store. The purpose of this obligation is to ensure that bat-
teries are disposed of in a non-polluting manner. Only dispose of batteries when
they are fully discharged.
SHBS 1000 A1
off the appliance.
7
.
to engage again by pressing lightly from behind
under running water.
7
thoroughly afterwards.
7
from its holder (see Fig. D), press your thumbs
back
GB
MT
53