Data Analysis And Measurement Result Description - Gema Cardio-C Manual De Uso

51
return key to exit! ", at this time, connect to external power can continue
to measure, or exchanging a new battery to measure again.
• During measuring mode, it will have regular pulse beep sound.
• During the measurement by external lead wires, if "HR alarm" option
is set to "On" and the HR value is out of the alarm limits, the alarm sounds
will occur with 3 short beeps, and the HR value is reversely displayed.
• During the quick measurement, if the device does not check well contact
with the electrodes or the signal is poor, it will not be calculate the average
HR value, the measuring result is "poor signal, measure again", this data
will not be saved.
• During the measurement, if the placement of electrodes loose contact
with the electrodes, it will prompt "poor signal". If it is external lead wire
measurement, the HR value shows "__".

4.4 data analysis and measurement result description

When the measuring is finished, the device will analyze the measurement
result, as shown in figure 4.11/4.12/4.13; the measurement result description
refers to the index 2.
Figure 4.11
No irregularity found
Quick measurement
1. In the external lead wire measuring mode,
the current measurement result will be saved
acquiescently, as shown in figure 4.12/4.13.
Press the "" ok key or "" back to return the
default menu screen after reviewing the result.
2. After the quick measurement by built-in
electrodes, the device will be saved the result
automatically, and it prompts "The result is
saved successfully, as shown in figure 4.14.
Press the "" ok key or "" back to return the default
menu screen. If without any key operation in 6 seconds, press "" back
key, return to default menu screen directly and the current measurement
result won't be saved.
Figure 4.12
No irregularity found in Ext.
ENGLISH
Figure 4.13
Irregularity found in Ext.
Figure 4.14