Pinp Settings - Panasonic AW-HS50E Manual De Uso

1. Basic operations

1-4-3. PinP settings

Settings can be selected for the PinP images.
 Shape 
[3] PinP Menu
1. Shape
This item enables any of the following shapes to be selected
when combining the PinP image.
Shape of PinP
Square Circle
 Pos:X/Y/Size 
[3] PinP Menu
2. Pos:X/Y/Size
This item is used to adjust the centre position
(X: X coordinate and Y: Y coordinate) and size (S) of the
PinP image.
<Setting range of the X and Y coordinates>
Y
(Pos-Y)
Heart Flower Star
X
(Pos-X)
Inside screen area
Outside screen area
  When the submenu [3] PinP Menu is displayed, direct
operations using the USER buttons and OSD/TIME dial
are enabled.
 Refer to "2-5-6. Direct operations using the USER
buttons and OSD/TIME dial" (<Basics> Operating
Instructions).
<Direct operation status display>
U1: Pos-X (X coordinate), U2: Pos-Y (Y coordinate),
U3: Size, U4: —
Note
The size of the image cannot be changed when the
Dot by Dot mode has been set for the PinP material.
 PVW 
[3] PinP Menu
3. PVW
This item makes it possible to establish the setting for
outputting the PinP image to the PVW image.
 Border Width 
[3] PinP Menu
4. Border/Soft
[B: Border]
This is used to set the width of the PinP image border.
 Set "0.0" when the border effect is not going to be
added.
[S: Soft]
This is used to set the amount of the PinP image's soft
effect.
 Set Border Col 
[3] PinP Menu
5. Set Border Col
This item is used to select any of the following colours for
the borders of the PinP image.
White, Yellow, Cyan, Green, Magenta, Red, Blue, Black
 Adj Border Col 
[3] PinP Menu
6. Adj Border Col
This item is used to adjust the hue (H), saturation (S) and
luminance (L) of the colour which has been set for the
borders of the PinP image.
17 (E)