Switching The Aux Output; Selecting The Aux Bus Material; Transitions Between Aux Materials - Panasonic AW-HS50E Manual De Uso

1. Basic operations

1-7. Switching the AUX output

1-7-1. Selecting the AUX bus material

The AUX output material is selected using the A bus and B
bus crosspoint buttons.
1
Press the AUX button to set the crosspoint
buttons to the AUX bus material selection
mode.
The indicator of the AUX button blinks.
2
Select the material using the A bus or B bus
crosspoint buttons.
[A bus crosspoint buttons]
When buttons [1], [2], [3], [4] and [5] are pressed, PGM,
PVW, KEY OUT, CLN or MV are selected, respectively.
[B bus crosspoint buttons]
When the buttons from [1] to [5] are pressed, the
materials assigned to the corresponding XPT1 to XPT5
are selected.
When the button from [1] to [5] are pressed while the
SHIFT button is held down, the materials assigned to
the corresponding XPT6 to XPT10 are selected.
3
Press the AUX button to release the bus
selection mode for the crosspoint buttons.
1, 3 2
AUX PinP KEY-F/S MIX
BUS DELEGATION TRANSITION TYPE
KEY-S
AUX
PGM PVW KEY OUT CLN
1 6 2 7 3 8 4
KEY-F
PinP
AUX
WIPE PinP ON KEY ON FTB ON
A
SHIFT
MV CUT
9 5 10
B
SHIFT
AUTO
BKGD

1-7-2. Transitions between AUX materials

When an AUX bus material has been selected, the effect to
be produced when images are switched can be executed as
a MIX transition. (Bus transition function)
[1] TIME/CBGD Menu
6. AUX BUS Trans
Set the transition duration, and set the bus transition
function to "Enable" or "Disable".
While the transition is underway, the indicator of the
transition source button lights, and the indicator of the
transition destination button blinks.
When the transition is completed, the indicator of the
transition source button goes off, and the indicator of the
transition destination button lights.
When another signal has been selected while a transition is
underway, the processing for the transition will continue from
the interim point.
22 (E)