Filling Water Into The Water Tank; Adding Essential Oils; Starting The Vaporization Process - EASYHOME MD19143 Manual Del Usuario

Filling water into the water tank

1. Make sure the product is switched off and the power adapter
disconnected from the base unit
2. Remove the mist nozzle
off of the base unit (see Fig. D).
3. Turn the water tank upside down and unscrew the water tank cap
Fig. E).
4. Fill the water tank with clean water below 113 °F (45 °C) (see Fig. F). Do not
overfill the water tank.
5. Replace and tighten the water tank cap. Dry any spilled water on the water
tank if necessary (see Fig. G).
6. Place the water tank onto the base unit and replace the mist nozzle on the
water tank (see Fig. H).

Adding essential oils

1. Lift the water tank
2. Add a few drops of your desired essential oil on the aroma tray with aroma
pad 8 in the base unit (see Fig. I).
The aroma pad should only be continuously used for the same
type of essential oil. Before reusing the aroma pad with another
essential oil, clean it gently in warm water and allow it to air dry
thoroughly.

Starting the vaporization process

1. Fill the water tank
previous chapters.
2. Connect the power adapter
properly installed and easily accessible outlet (see Fig. C).
3. Adjust the mist nozzle
4. Turn the moisture output control knob
on. Adjust the desired moisture output by turning the moisture output
control knob between the
The power indicator
begins.
5. Turn the moisture output control knob to the I/O position to end vaporization.
The power indicator turns red when the water level is low and
the vaporization process is about to end. Turn the moisture
output control knob to the OFF position, unplug the product and
refill the water tank before using the product again.
7
1 from the water tank
2 off of the base unit
2 and add your desired essential oil as described in
9 to the base unit
1 so that it faces a proper direction.
and
6 lights up green and the vaporization process
and the power outlet (see Fig. B).
2 and lift the water tank
7 .
7 and plug it to a
5 to the right to switch the product
positions (see Fig. J).
Operation
9 is
10 (see
13