Emptying The Dust Cup Assembly - Shark UV300 Manual Del Usuario

Emptying the Dust Cup Assembly

For best results empty the Dust Cup Assembly after
each use; or as needed during prolonged usage. or
when it reaches the MAX fill line.
DO NOT OVERFILL.
Turn vacuum off before emptying.
Dust cup
Release
Button
Fig. 13
TO EMPTY THE DUST CUP
ASSEMBLY:
1
Press the Dust Cup release
button ( )and remove the dust
cup from the vacuum. (Fig. 13)
2
Grip carry handle and press the
bottom Dust Cup Door release
button. (Fig. 14)
3
Option A: for Quick Empty:
Insert Dust Cup Assembly deep
inside trash receptacle to contain
dust and debris. (Fig. 15)
Press the bottom Dust Cup Door
release button; tap container
gently to dislodge and release
dust and debris.
Close the bottom door until it
snaps in place.
Important: If the Dust Cup
Door does not swing open freely
after pressing the release button,
push the door open using the
bottom door tabs.
UV300_26_IB_ENG_SPA_111005_1.indd 7
Fig. 15
4 Option B: For Allergy Sufferers:
Wrap a trash bag around the
Dust Cup Assembly leaving
space at the bottom for the door
to swing open. (Fig. 16)
Locate the Dust Cup Door
release button within the trash
bag and press to release as you
shake the dust cup to empty
dust and debris.
Close the bottom door until it
snaps in place.
Note: Option B can also be
performed outside of the home
to further minimize releasing
dust back into the air. Carry just
the Dust Cup Assembly and trash
bag outside.
Fig. 14
Fig. 18
Note: It may become necessary
to occasionally clean the metal
screen inside the dust cup. To
clean, press the top dust cup
release button (Fig. 17), pull out
the metal screen and remove
any excess dirt. Then replace the
metal screeen inside the dust
cup and close the top lid.
(Fig. 18)
www.sharkclean.com
English
Fig. 16
Fig. 17
7
12-05-23 11:45 AM