Kenwood CCD-2000 Manual De Instrucciones página 5

Installation for Camera Unit
Installation for Camera Unit
1 Clean the surface to which the rear view camera
is to be installed. Use a cloth or other item to wipe
oil, wax, dust and any other dirt from installation
surface.
2CAUTION
• Locate the rear view camera in the position you want it
installed. Adjust the angle of the rear view camera, and
install so that the camera doesn't touch the car.
• When sticking to a glass surface, stick it on in a position
that assures the camera doesn't touch the rear window.
2 Peel off the sheet on back of the camera bracket
(Accessory3) and stick it on.
2CAUTION
• Press the camera bracket with your fingers to stick it to
installation surface. Touching the adhesive surface or
sticking the unit on a second time reduces adhesive
strength, which may result in the unit falling.
• If the temperature of the attachment surface is low,
warm with a hair dryer or other means before installing
to improve adhesive strength.
3 Attach the rear view camera to the camera
bracket (Accessory3) with the installation screws
(Accessory4).
2CAUTION
• The rear view camera is attached so that the logo of
Kenwood is on the upper surface.
4 Adjust the angle so that bumper or rear edge of
the car is displayed at the bottom of the monitor
screen.
Installation example
Install on the center part
Glass surface
Screw (Accessory4)
130°
Monitor screen
Bumper or rear edge of car
Camera bracket (Accessory3)
Camera bracket (Accessory3)
96°
|
English
5