Use - Vermeiren LiNX LE Manual De Instrucciones

OPERATOR CONTROL LiNX LE

1. Use

The operator control built into your electric wheelchair enables you to control all the driving, steering,
braking and operating processes. The wheelchair's electrical unit and electronics are constantly being
monitored internally. Any fault in the electronics is indicated on the status indicator (1) (see the chapter
on troubleshooting).
Vermeiren is responsible for the changes in the software. For changes in the software contact
Vermeiren.
L
WARNING:
Risk of burns – Be aware that the surface of the operator control can
potentially get hot when it is exposed to strong sunlight for long periods.
1 = "ON / OFF" button,
Status indicator
2 = Battery charge
indicator
3 = Speed switch
left : slower
right : faster
4 = "Horn" button
5 = Joystick
6 = Software installation
7 = Charger connector
L
Note that, when pressing the "ON/OFF" button, the joystick stays in the central position for at
least five seconds. It is programmed this way for technical and safety reasons, to
joystick being pushed at the same time as the wheelchair is being switched on. If both
processes are activated at the same time, the steering unit locks itself and can only become
operational again after being switched off completely.
You can sound an acoustic warning signal with the "Horn" (4) button.
To brake while driving, simply push the joystick to its central position. Move the joystick slowly for
gradual braking. Simply release the lever for a quick stop; the wheelchair will then stop as quickly as
possible.
Press the "ON/OFF" button (1).
The charge indicator (2), which
also indicates the batteries' charge
level, lights up for a moment. If all
the lights come on, the batteries
are sufficiently charged. If the
lights do not all come on, you must
adjust your driving activities to suit
the low capacity of the batteries. If
the battery charger display lights
do not come on, check the plug
connections of the electronic
system.
Now select the driving program
you want by turning the speed
switch (3), left turn to go slower
and right turn to go faster.
To set the wheelchair in motion,
push the joystick forwards slowly.
The speed will increase when you
push the joystick further forwards.
If you want to turn left or right,
simply push the joystick in the
desired direction. To reverse, pull
the joystick backwards from the
central position.
2
LiNX LE
vA - 2013-05
prevent the