Publicidad
CABLE OPERATED MANUAL ATTACHMENT CLUTCH
STEP 35: (SEE FIGURE 35)
•
Attach the two suspension arms to the rear of the
clutch/idler assembly using two 5/16" x 3/4" hex bolts
(C), 5/16" washer (Q) and 5/16" nylock nuts (Y) for
each arm. Place the arms on the outside of the frame
with the notches to the rear.
•
Insert a tensioning chain through the hole shown and
attach the end link to the spring on the lower idler arm.
5/16" NYLOCK
NUT (Y)
5/16" WASHER (Q)
5/16" x 3/4"
HEX BOLT (C)
FIGURE 35
STEP 36: (SEE FIGURE 36)
•
Assemble the cable bracket to the clutch/idler
assembly using two 5/16" x 3/4" carriage bolts (K) and
5/16" nylock nuts (Y). Use the two front holes in the
cable bracket if your tractor has a 42" mower deck.
Use the two rear holes if your tractor has a 46" mower
deck.
46"
42"
DECKS
DECKS
FIGURE 36
STEP 37: (SEE FIGURE 37)
•
Two different length drive belts are included with
your snow thrower. Tractors with manual attachment
clutches and dual front deck suspension brackets use
the 55" drive belt with #46989 printed on the outside
of the belt. DO NOT USE the other belt.
TENSIONING CHAIN (JJ)
5/16" x 3/4"
CARRIAGE BOLT (K)
CABLE
BRACKET
5/16" NYLOCK
NUT (Y)
•
Slightly loosen the hex bolt next to the flat idler pulley.
Install the drive belt down between the hex bolt and the
flat idler pulley with the flat side of the belt against the
pulley. Retighten the hex bolt.
•
Loop the belt around the large v-pulley, placing it
between the v-pulley and the hex bolt next to the pulley.
HEX BOLTS
(#46989)
DRIVE BELT
FIGURE 37
Did you choose the correct drive belt for
your tractor? Using the wrong length belt
STOP
may cause premature bearing or belt failure.
STEP 38: (SEE FIGURE 38)
•
Move the attachment clutch lever on the dash panel to
the disengaged (down) position.
•
Place the clutch/idler assembly on the floor on the right
side of the tractor.
•
Attach the tractor's clutch cable to the cable bracket.
Secure the cable housing guide (groove down) to the
cable bracket using the original collar and a 5/64" hair
cotter pin (DD).
•
Place a spacer (LL) on the welded pin on the idler arm.
Hook the end of the clutch spring over the pin and
secure it with a 1/4" washer (P) and a 5/64" hair cotter
pin (DD).
5/64" HAIR
COTTER PIN (DD)
1/4" WASHER (P)
TRACTOR'S
CLUTCH CABLE
FIGURE 38
5/64" HAIR
18
COTTER PIN (NN)
FLAT IDLER
PULLEY
SPACER (LL)
5/64" HAIR
COTTER PIN (DD)
Publicidad
