Innotek FieldPro FP-RANGER-E Manual Del Propietário página 3

Step 1
AC Adapter
1 1 . . Plug the AC Adapter into a 220VAC
outlet.
2 2 . . Connect the AC Adapter to the "Y"
cable.
3 3 . . Connect the "Y" cable to the Receiver
Cradle.
4 4 . . Put the Receiver on the Receiver Cradle as
shown in figure 4. The light on the Receiver
glows red while charging, and glows green
when fully charged. If you don't see a light
glowing, try turning the Receiver around on the
Cradle.
5 5 . . On the Transmitter, move the Charge Port Cover away
from the Charge Port. Connect the remaining end of the
"Y" cable to the Transmitter's Charge Port. Charge the
transmitter for at least 2 hours.
To maintain maximum range, keep the Transmitter antenna away
from all magnets (there is a magnet in the Charging Cradle).
Exposure to a magnet may permanently diminish range.
FieldPro-E Owner's Manual
Charging the Batteries
1 1
From AC Adapter to "Y" Cable
2 2
"Y" Cable
RANGER ™ Quick Start Guide
3 3
to Receiver Cradle
4 4
Back view of Ranger Transmitter
5 5
LED LIGHT
Charge Port Cover
EN-3