Cameo CLSTORM Manual De Usuario página 11

OPERATION:
NOTES: A few seconds after connecting to the power supply, the projector
is ready for operation and the operating mode that was previously selected
is activated.
If inputs, such as program selection or running speed are not confirmed
within about 4 seconds by pressing the ENTER button, the previously selec-
ted mode, or the previously set value is automatically activated.
DMX CONTROL AND ADJUSTMENT OF DMX START ADDRESS
Press the MODE button repeatedly until the LED indicator for the DMX
controller (DMX) lights up and displays the DMX start address on the display
(A001 - A506). While all four characters are flashing on the display, the DMX
start address can then be set as desired using the UP and DOWN buttons. To
confirm, press ENTER. If a DMX signal is present at the DMX input (DMX IN),
the flashing of the four characters on the display stops and only a small dot
after the first character starts flashing; if there is no DMX signal, all four cha-
racters on the display continue flashing. To select a different DMX address,
press MODE again, and then proceed as described above. The synchronous
control of several projectors of the same model through a DMX controller (eg
DMX console) can be achieved by adjusting the projectors on an identical
DMX-starting address and connecting them using DMX cables.
AUTOMATIC CONTROL
Press the MODE button repeatedly until the LED indicator for the automatic
control (AUTO) lights up and displays one of the 7 auto programs on the
display (Aut0 - Aut6). While all four characters are flashing on the display,
one of the programs can then be selected using the UP and DOWN buttons.
After confirming by pressing the ENTER button, you can now select the
speed at which the selected program is running by using the UP and DOWN
buttons (the display shows: S 100 = maximum speed, minimum speed =
S 1). Confirm with ENTER. To select a different program, press MODE again,
and then proceed as described above.
MUSIC CONTROL
Press the MODE button repeatedly until the LED indicator for the music con-
trol (SOUND) lights up and displays one of the 7 programs for music control
on the display (Sou0 - Sou6). While all four characters are flashing on the
display, one of the programs can then be selected using the UP and DOWN
buttons. Confirm the entry by pressing ENTER. To adjust the sensitivity with
which the projector reacts to music signals (bass impulses), select SENSI-
TIVITY on the controller. When turned to the left, the sensitivity is lowered,
when turned to the right, it is increased. To select a different program, press
MODE again, and then proceed as described above.
11