Important - Yamaha SWR2311P-10G Manual De Instrucciones

FCC INFORMATION (U.S.A.)
1. IMPORTANT NOTICE:
DO NOT MODIFY THIS UNIT!
This product, when installed as indicated
in the instructions contained in this man-
ual, meets FCC requirements. Modifica-
tions not expressly approved by Yamaha
may void your authority, granted by the
FCC, to use the product.

2. IMPORTANT:

When connecting this
product to accessories and/or another
product use only high quality shielded
cables. Cable/s supplied with this product
MUST be used. Follow all installation
instructions. Failure to follow instructions
could void your FCC authorization to use
this product in the USA.
3. NOTE:
This product has been tested and
found to comply with the requirements
listed in FCC Regulations, Part 15 for
Class "A" digital devices. Compliance with
these requirements provides a reason-
able level of assurance that your use of
this product, in a commercial environment,
will not result in harmful interference with
other electronic devices. However, opera-
tion of this product in a residential area is
likely to cause interference in some form.
In this case you, the user, bear the respon-
sibility of correcting this condition.
This product generates/uses radio fre-
quencies and, if not installed and used
according to the instructions found in the
users manual, may cause interference
harmful to the operation of other electronic
devices. Compliance with FCC regulations
does not guarantee that interference will
not occur in all installations. If this product
is found to be the source of interference,
which can be determined by turning the
product "OFF" and "ON", please try to
eliminate the problem by using one of the
following measures:
Relocate either the product generating the
interference or the device that is being
affected by the interference.
Utilize power outlets that are on different
branch (circuit breaker or fuse) circuits or
install AC line filter/s.
In the case of radio or TV interference,
relocate/reorient the antenna. If the
antenna lead-in is 300 ohm ribbon lead,
change the lead-in to co-axial type cable.
If these corrective measures do not pro-
duce satisfactory results, please contact
the local retailer that is authorized to dis-
tribute this type of product. If you can not
locate the appropriate retailer, please con-
tact Yamaha Corporation of America, Elec-
tronic Service Division, 6600
Orangethorpe Ave, Buena Park, CA90620
The above statements apply ONLY to
those products distributed by Yamaha Cor-
poration of America or its subsidiaries.
(class A)
SWR2311P-10G Owner's Manual
3