Other Functions - Steren HER-408 Manual De Instrucciones

Automatic measurement recording
If you activate this function, the luxometer will make continuous measurements, at intervals
of 10 seconds, and save them automatically.
1. To enter recording mode, press and hold the MODE button until the REC symbol
appears on the screen.
2. Press to start or stop the measurements.
HOLD
UNIT
To view the saved measurements, press the MODE button. The READ symbol will flash on
the screen. Press
HOLD
UNIT
To clear the measurements, press the MODE button until the DEL symbol appears on the
screen. Then press
If the screen shows - - - - it means that there is no saved measurement.
Illumination on the screen
Press the button
Data retention
Press the button
HOLD
UNIT
screen.
Indicators of high or low luminosity
When the brightness value is higher than the range, the HI symbol flashes continuously on
the screen; when it is lower, LO appears

Other functions

to see the next saved measurement.
to confirm.
HOLD
UNIT
once to turn the backlight on or off on the screen.
if you wish to retain the data of the last recorded reading on the
6