SEVERIN KS 9783 Instrucciones De Uso página 15

3. Take off the upper hinge by removing the 3 screws.
Remove the hinge pin on the underside of the hinge. Turn
the plate around and re-fi t the hinge pin, again from below.
Put the hinge assembly aside for now, to be installed later
at step 13. Take off the upper door and place it on a soft
surface to protect it from scratches.
4. Pull out the two screws which hold the centre hinge in
position. Remove the hinge, turn it through 180° and put
it aside, to be installed later at step 9. Take off the lower
door and place it also on a soft surface to protect it from
scratches.
5. Remove all four of the blind covers over the hinge
mounting holes on the left of the unit and the freezer door,
and replace them in the corresponding places on the right.
6. Remove both adjustable feet, the screws holding the lower
hinge and the mounting plate.
7. Remove the lower hinge and the mounting plate. Unscrew
the hinge pin and mount it on the opposite side of the
hinge. Now fi t the hinge on the left-hand side (Note: do
not fully tighten the screws yet). Fit the mounting plate on
the right.
8. Change the hinge-pin set-up on the underside of the
freezer door from right to left. Fit the freezer door onto the
lower hinge-pin. Align the door along its outside edges,
and tighten the screws of the hinge. Now proceed to fi t
both adjustable feet.
9. Take the centre hinge (removed in step 4), fi t the hinge pin
into the corresponding opening on the freezer door and
tighten the screws on the hinge.
15