Kenwood KSC-SW10 Manual De Instrucciones página 7

Installation
Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
• Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the vehicle compartment.
• Fix the product firmly so that it will not be moved by vibrations or impacts during driving.
Fixing the cord in place
4 Machine screw x 2
3 Fixture C
(Fig. 1)
Fixing the subwoofer
Flat installation
4 Machine screw x 4
1
1 Fixture A x 2
Attach the fixtures A 1 to the speaker unit securely
using the machine screws 4 . Be careful so that the
connected cords do not get in between the speaker
unit and fixtures A 1 .
2
Drill the pilot holes for φ . mm screws on the sheet
metal section of the vehicle , and attach the speaker
unit to the vehicle using the tapping screws 5 .
Installing the remote control unit
Install the remote control unit on the vehicle by the
provided Velcro tape.
Vehicle
7 Velcro tape
(Harder surface)
6 10-pin connector cord
9 RCA cord
8 Remote
control
(Fig. 2)
Caution:
This portion becomes slightly
h ot ter than oth er p o r ti o ns
because it functions as the ra-
diator of the heat generated by
the amplifier.
5 Tapping screw x 4
Drill four pilot holes for
ø 3.6 mm screws.
8 Remote
control
7 Velcro tape
(Softer surface)
Rear panel
1 Connect the 10-pin connector cord 6 , RCA cord 9 ,
and remote control 8 to the speaker unit. (Fig. 1)
( When connecting the speaker input terminal,
RCA cord is not necessary.)
( The cords to be connected depends on the sys-
tem. Refer to Connection of example.)
2 Fix the cords to the speaker unit with fixture C 3 ,
and fix in place with the machine screws 4 . (Fig. )
Side installation
1
Holes not
used
4 Machine
screw x 6
2 Fixture
B x 2
Adjust the installation height so that the speaker
unit will not rattle, and attach the bracket B 2 to the
subwoofer using the machine screws 4 .
2
2 Fixture B x 2
Drill the pilot holes for φ . mm screws on the sheet
metal section of the vehicle, and attach the speaker
unit to the vehicle using the tapping screws 5 .
Caution:
Install the remote control unit in a position that does not come
in the way of driving operations.
Avoid installing it in a place subject to direct sunlight or direct
hot wind from the heater. Otherwise, the product may be
degraded and a fire hazard may result.
Remove dirt from the installation position before attaching the
Velcro tape. When the Velcro tape is attached on the remote
control unit, it cannot be accommodated in the main unit.
Holes not
used
5 Tapping screw x 6
Drill six pilot holes
for ø 3.6 mm
screws.
English