Kenwood KSC-SW10 Manual De Instrucciones página 8

Operation
Name of each part (Remote control)
Power indicator
Red glows
Power ON
Adjusting the sound (Remote control operation)
1 Turn the FREQUENCY control knob to adjust the
cut-off frequency (frequencies higher than this
frequency are cut off).
2 Turn the LEVEL control knob to adjust the low
frequencies to the desired level.
3 Adjust the low frequency phase.
The low frequency tone may be variable depending on the po-
sition of the unit, its orientation or the turn-over frequency. This
can be adjusted by changing the position of the PHASE switch.
Set this switch to either position according to your liking.
[[0°] indicates the normal phase and [180°] means the reverse
phase.
Fuse exchange
Exchange with the specified capacity fuse.
Removal
Cover
Fuse
Fuse holder
1 Open the cover.
2 Grasp with pliers and pull up.
8
English
PHASE switch
(Phase select switch)
FREQUENCY control knob
(Cut-off frequency control knob)
LEVEL control knob
(Input sensitivity control knob)
Power indicator
(Power display light)
Light is OFF
Power OFF
Be sure to replace with same capacity (amperage) as displayed on the fuse. This product is 10A.
Caution:
The illumination on the subwoofer turns on and off
in an interlocked operation with the PWR indicator
on the remote control unit.
Illumination
Turn the FREQUENCY control knob to adjust the balance between the
bass from the rear speakers and the bass from this unit as desired.
MAX
MIN
LOW FREQUENCY
Insertion
Replacement fuse 10 A
1 Insert the fuse gently into the fuse holder and
push in all the way with your finger.
2 Close the cover.
HIGH