Publicidad
Idiomas disponibles
Idiomas disponibles
Service
Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements
are available at your local
Sears service dealer.
To service the air cleaner, follow these steps:
1.
Loosen screw and tilt cover down.
Tabs and Slots
Cartridge
Base
Cover
2.
Carefully remove cartridge assembly.
3.
To clean cartridge, gently tap pleated paper side
on a flat surface.
4.
Reinstall clean or new cartridge assembly inside
cover.
5.
Insert cover's tabs into slots in bottom of base.
6.
Tilt cover up and tighten screw securely to base.
NOTE: You can purchase new air filter elements by
calling 1-800-4-MY-HOME (469-4663).
Service
Spark
Plug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug if the electrodes are worn, or if
the insulator is cracked or chipped.
4.
For replacement use either the standard resistor
spark plug, Champion RJ19LM or the long life
platinum spark plug, Champion QC12YC.
5.
Check electrode gap with wire feeler gauge and
set gap at 0.030 inches (0.76mm), if necessary.
_-_
............
Spark Attester
Service
Your engine is not factory-equipped with a spark arrester.
In some areas, it is illegal to operate an engine without a
spark arrester. Check local laws and regulations. A spark
arrester is available from your nearest Sears service
dealer. If you need to order a spark arrester, please call
1-800-4-MY-HOME (469-4663).
The spark arrester must be serviced every 50 hours to
keep it functioning as designed.
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing the
spark arrester.
WARNING
DO NOT touch hot surfaces
and avoid hot exhaust
gases.
Allow
equipment
to cool before
touching.
Keep at least 5 ft. (152 cm) clearance
on all sides
of
pressure
washer
including
overhead.
Code of Federal
Regulation
(CFR)
Title 36 Parks,
Forests,
and Public
Property
require
equipment
powered
by an internal
combustion
engine
to have a spark
arrester,
maintained
in effective
working
order,
complying
to USDA
Forest
service
standard
5100-1C
or later
revision.
In the State of California
a spark
arrester
is
required
under section
4442
of the California
Public
resources
code.
Other
states
may have similar
laws.
*
Remove spark arrester screen for cleaning and
inspection.
*
Replace if screen is damaged.
Air Cooling
System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly.
For this reason, we recommend you
have a Sears or other qualified service dealer clean
the cooling system per recommended intervals (see
"Maintenance Schedule" on page 16). Equally
important is to keep top of engine free from debris.
See "Clean Debris".
Clean Combustion
Chamber
We recommend you have a Sears or other qualified
service dealer remove combustion deposits from the
cylinder, cylinder head, top of piston and around valves
per recommended intervals (see "Maintenance
Schedule" on page 16).
6.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-4-MY-HOME (469-4663).
19
Publicidad
