Fagor 8H-885ADTFTN Manual De Instrucciones página 62

OPERATION
NOTE: Danger of burns! Hot steam may es-
cape when you open the oven door. Be careful
when you open the oven door during or after
cooking. Do NOT lean over the door when
you open it. Please note that depending on
the temperature the steam can be invisible.
IMPORTANT: Ensure there is no water in
the steam system when you use standard
heating functions. Do not add water into the
container drawer when using the standard
heating functions.
Descale the steam system
When you have run several steam pro-
grammes, a flashing "Descale" message
will be shown on the display. This message
prompts you to descale the system. You can
skip descaling twice, by touching the
sor. However, eventually the appliance will not
allow you to run a steam programmes again
until you descale the appliance.
When you select the "Descale" programme,
the display will show the message "Add 0.5l
of descaling agent." During the program, you
will see the messages "Add 0.5l of water" and
"Remove water" (rinsing).
Descale the appliance.
• Prepare the solution of 450 ml of water
and 50 ml of liquid descaling agent.
• Pour the solution into the water contain-
er drawer.
• Press OK to start the "Descale" pro-
gramme.
NOTE: During the descaling programme,
you will need to drain water from the steam
system 3 times.
Drain the descaling solution from the system
when you hear a beep and the "Remove water"
message is flashing.
• Open the oven door.
• Then place deep baking tray under the
62
water drain.
• Press OK to drain the remaining des-
caling solution from the steam system.
Pour the solution out of the baking tray
and rinse it with water.
Add water when you hear beeping and the
message "Add water" is flashing on the display.
To rinse the steam system, pour 0.5 l of clean
water into the water container drawer and
touch OK to continue the programme.
Drain the water from the system when you
hear a beep and the "Remove water" mes-
sage is flashing.
• Open the oven door.
• Then place deep baking tray under the
water drain.
• Press OK to drain the remaining water
from the steam system. Pour the solu-
sen- tion out of the baking tray and rinse it
with water.
IMPORTANT: If water is dripping from the
drain tube during the steam programme, flush
the system. When the appliance is on but no
function is active:
• Place at least 1 litre container under the
drain.
• Pour 0.5 litres of water into the water
container drawer.
• Simultaneously touch the
and drain water out of the system.
• Repeat this procedure twice.
If the problem persists, descale the appliance.
IMPORTANT: If you notice scale draining
from the steam system after the completed
steam programme, select the "Descale" pro-
gramme from the list and follow the descaling
instructions.
If you pour water into the container but decide
not to run a steam programme, you can touch
the sensors to drain water from the
steam system.
sensors