Before Installing - Sony XVM-R75 Manual De Instrucciones

Ocultar thumbs Ver también para XVM-R75:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Where to install
Before installing this unit, please check your local traffic rules and regulations.
Follow the diagram below to install this unit in a suitable position in your car.
Approximately
300 mm (11
Do not install this unit where:
- It will obstruct the driver's view when the monitor is in either the open or closed
position.
- It will obstruct the operation of the airbag system.
- It will obstruct the operation of the vehicle, especially
the steering wheel, shift lever, or brake pedal.
- A driver or passengers may injure themselves when
getting into or out of the car.
If you have any questions or problems concerning your unit that are not covered
in this manual, please consult your nearest Sony dealer.

Before installing

Make sure that the POWER SELECT switch is set to the
correct position.
A: If your car has an accesory position on the ignition key.
B: If your car has no accesory position on the ignition key.
When the POWER SELECT switch is set to B
The (OPEN/CLOSE) on the Overhead monitor turns the
power on.
You cannot turn on the power by the (POWER) on the
card remote commander. However, when the power is
already on, you can operate the unit with the card
remote commander.
Note
When you get out of the car, be sure to turn off the power
by the (OPEN/CLOSE) on the Overhead monitor, or the
(POWER) on the card remote commander.
If the power is left on, it will cause battery drain.
6
Approximately
150 mm (5
13
/
in.)
16
15
/
in.)
16
B
A
Receptor for the card remote
commander

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido