Maintenance And Storage - Makita DUB362 Manual De Instrucciones

Preparation
5. Obtain ear protection and safety glasses. Wear them
at all times while operating the blower.
6. Always wear substantial footwear and long trousers
while operating the blower.
7. Do not wear loose clothing or jewellery that can be
drawn into the air inlet. Keep long hair away from
the air inlets.
8. To prevent dust irritation the wearing of a face mask
is recommended.
Operation
9. Operate the blower in a recommended position and
only on a firm, level surface.
10. Never point the nozzle at anyone in the vicinity when
using the blower.
11. Never block suction inlet and/or blower outlet.
• Do not block suction inlet or blower outlet to clean
up in dusty areas.
• Do not use the blower with a tapered nozzle
smaller than the original one, such as a new nozzle
obtained by attaching an extra diameter-reduced
hose or smaller hose to the nozzle top end.
• Do not use the blower to inflate balls, rubber boat
or the similar.
Increased motor revolution may cause dangerous
fan breakage and result in serious personal injury.
Heated motor and control circuit may cause a fire.
12. Do not overreach and keep proper balance and
footing at all times. Always be sure of the footing on
slopes and to walk, never run.
13. Do not operate the blower on a paved or gravel
surface where ejected material could cause injury.
14. Never operate the blower while people, especially
children, or pets are nearby.
15. Do not operate the blower near open window, etc.
16. Operating the blower only at reasonable hours is
recommended - not early in the morning or late at
night when people might be disturbed.
17. Using rakes and brooms to loosen debris before
blowing is recommended.
18. It is recommended to slightly dampen surfaces in
dusty conditions or use mister attachment available
on the market.
19. It is recommended to use the long nozzle so the air
stream can work close to the ground.
20. If the blower strikes any foreign objects or should
start making any unusual noise or vibration,
immediately switch off the blower to stop it. Remove
the battery cartridge from the blower and take the
following steps before restarting and operating the
blower:
• inspect for damage,
• when the blower is damaged, have it repaired by
Makita Authorized Service Centers.
21. Switch off the blower and remove the battery
cartridge and make sure that all moving parts have
come to a complete stop
• whenever you leave the blower,
• before clearing blockages or unclogging chute,
• before checking, cleaning or working on the blower,
• if the blower starts to vibrate abnormally, for
immediately check, or
• after striking a foreign object to inspect the blower
for damage.
22. Do not insert fingers or other objects into suction inlet
or blower outlet.
23. Prevent unintentional starting. Ensure the switch is in
the off-position before inserting battery pack, picking
up or carrying the blower. Carrying the blower with
your finger on the switch or energising the blower
that has the switch on invites accidents.

Maintenance and storage

24. When the blower is stopped for servicing, inspection,
or storage, or to change an accessory, shut off the
power source, remove the battery cartridge from the
blower and make sure that all moving parts come
to a complete stop. Cool down the blower before
making any inspections, adjustments, etc. Maintain
the blower with care and keep it clean.
25. Store the blower in a dry place out of the reach of
children.
26. Always cool down the blower before storing.
27. Keep all nuts, bolts and screws tight to be sure the
blower is in safe working condition.
Battery tool use and care
28. Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
29. Use the blower only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE
or failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
IMPORTANT SAFETY INSTRUCTIONS
FOR BATTERY CARTRIDGE
1. Before using battery
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively
shorter, stop operating immediately. It may result
in a risk of overheating, possible burns and even
an explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any
conductive material.
(2) Avoid storing battery cartridge in a container
with other metal objects such as nails, coins,
etc.
ENC007-11
cartridge, read all
5