Pairing - Sony HWS-BTA2W Manual De Instrucciones

Pairing

Check the following before operating the unit.
– The TX/RX switch is set to "TX."
– This unit is connected to a power source and the 1 indicator (green) goes off.
1
Press and hold the ID SET button for 7 seconds or more.
When the 1 indicator (green) and
button. This unit enters pairing mode.
Note
Pairing mode is canceled and this unit is turned off after about 5 minutes. If this unit is turned off
while performing the procedure, start over from step 1.
2
Set the BLUETOOTH stereo audio receiving device to pairing mode.
This unit searches the BLUETOOTH stereo audio receiving device automatically, and
pairs the device.
This unit tries to connect the BLUETOOTH stereo audio receiving device soon after
detecting it. When the BLUETOOTH connection is made properly, both the 1 indicator
(green) and
information is memorized on this unit.
Notes
• When pairing, be sure to place both the BLUETOOTH devices within 1 m (3 ft) of each other.
• Passcode of this unit is fixed to "0000." When using this unit as a transmitter, this unit cannot be
paired with a BLUETOOTH stereo audio receiving device whose Passcode is not "0000."
* Passcode may be called "Passkey," "PIN code," "PIN number," or "Password."
If pairing is not complete
Start over from step 1.
Tip
To pair with other BLUETOOTH devices, repeat steps 1 to 2 for each device.
Note
BLUETOOTH connection may be made on some devices automatically when pairing is complete. In such
a case, both the 1 indicator (green) and the
BLUETOOTH connection has been made.
16
US
indicator (blue) light up, indicating pairing is complete, and pairing
indicator (blue) start flashing together, release the
indicator (blue) light up, indicating that the