3
Select songs and start play on your iPod (see page 2 for compatible models), and put
the iPod into the main unit's connector.
The system charges the battery of iPod at the same time.
Use the remote or your iPod to play, stop and perform other operations.
When operating the iPod while it is in the connector, brace it with your other hand.
4
Adjust the volume using VOLUME +/– on the main unit.
Updating iPod software
Update your iPod to use the latest software before you use it.
Notes
• When the power switch ?/a is turned off, the AC power shuts down.
• Install this system so that the power switch ?/a can be turned off immediately in the event of trouble.
• When taking out or putting in the iPod, keep it straight and parallel with the rear support (A).
• Do not carry the system with an iPod set on the connector. Doing so may cause a malfunction.
• When taking out or putting in the iPod, brace the main unit with one hand and take care not to press the controls of
the iPod by mistake.
• The volume cannot be adjusted using the volume control on the iPod when it is connected to the system. Press
VOLUME + or – on the main unit to adjust the volume.
• Remove the protect case of the iPod before you insert it on the main unit.
To use the system as a battery charger
Turn on the subwoofer and put the iPod into the main unit's connector. Battery charging starts
automatically. The charging conditions appear in the iPod display. For details, see the user's guide of
your iPod.
GB
7