Troubleshooting; Specifications; Main Unit - Sony S-Master CPF-iP001 Manual De Instrucciones

Troubleshooting

Should you encounter a problem with your system,
find your problem in the troubleshooting checklist
below and take the indicated corrective action. If the
problem persists, contact your Sony dealer.
Note that if service personnel changes some parts
during repair, these parts may be retained.
When bringing the system in for repairs, be sure to
bring in the entire system.
This product is a system product, and the entire system
is needed to determine the location requiring repair.
The ON indicator flashes.
• The system is in protect mode. Turn the subwoofer
off and on.
There is no sound.
• Make sure the subwoofer is on.
• Check the connections.
• Press VOLUME + on the main unit. If the volume is
still low even after the system's volume is turned up
to the maximum level, adjust the volume of the
connected portable audio player (when using the
LINE IN jack).
• Remove the protect case of the iPod*, and make sure
the iPod is securely connected.
• Make sure the iPod* is playing music.
• Check that the correct function is selected.
• When there is no sound from the subwoofer, turn the
subwoofer off, and then turn it on again.
The remote does not function.
• Remove any obstacles.
• Point the remote at the main unit's sensor.
• Replace the battery.
• Locate the system away from fluorescent lights.
• Connect the iPod to the connector securely.
There is a severe hum or noise.
• Move the system away from the source of noise.
• Connect the system to a different mains.
The sound is distorted.
• Press VOLUME – on the main unit to reduce the
volume.
• Set the sound mode of the iPod to off or flat sound
quality.
FAQ
Can I use the buttons on the main unit to
operate the iPod*?
You cannot use the buttons on the main unit to
operate the iPod. Use the remote to operate the iPod.
Do I need to operate the iPod* to listen to
music?
You can also use the remote to listen to music. For
details about the operation of your iPod, refer to the
user's guide.
* See page 2 for compatible iPod models.

Specifications

Main unit

Continuous RMS power output (reference):
Inputs
iPod (dock connector):
LINE:
Speaker units:
Rated impedance (L/R):
Dimensions (w/h/d):
Mass:
Operating temperature:
Power requirements:
Subwoofer
Continuous RMS power output (reference):
Speaker units:
Rated impedance (SW):
Dimensions (w/h/d):
Mass:
Operating temperature:
Power requirements:
Design and specifications are subject to change
without notice.
5 W + 5 W
(1 kHz, 10% THD)
See page 2 for compatible
iPod models.
input mini jack (stereo)
28 mm dia.
8 Ω
Approx. 206 × 58 × 91 mm
Approx. 0.45 kg
10°C to 35°C
DC IN: 12 V, 1.0 A
15 W (100 Hz, 10% THD)
70 mm dia.
4 Ω
Approx. 218 × 74 ×
131 mm, incl. projecting
parts
Approx. 1.3 kg
10°C to 35°C
AC 220 V-240 V, 18 W,
50/60 Hz
(DC OUT: 12 V, 1.0 A)
GB
9