Step 4 - Convert Valves For Lp Gas - Bosch NGM5456UC Manual De Instrucciones

Install Burner Grates
Properly position and install each burner grate as shown
in the illustration below.
24" 4 Burner
WARNING
9
To prevent flare-ups, properly support pots and
avoid spills, all grates must be properly positioned
on the cooktop whenever the cooktop is in use. Do
not use a grate if the rubber feet are missing or
damaged.
For replacement of rubber feet: Call Customer Support
at 1-800-944-2904.

Step 4 - Convert valves for LP gas

The bypass jet on each valve must be adjusted. Your
cooktop has hollow valve shafts. Determine the bypass
screw location accordingly.
Turn all knobs to the "OFF" position.
1.
Remove knobs.
2.
Your appliance has hollow stem valves.
3.
Locate the correct point of insertion for the long, thin
flat blade screwdriver to adjust the bypass jet (see the
following illustration).
Hollow stem valve - insert a long, thin flat blade
A
screwdriver in the hollow stem of the valve. The
adjustment screw is approximately 1
from the top of the stem. The screwdriver slides
through a thin rubber barrier in the stem (helps
prevent damage in the case of a spill on the unit
surface).
Engage the tip of the screwdriver into the adjustment
4.
screw by slowly turning the screwdriver and feeling for
the blade to engage the screw. Then turn the screw
clockwise about 70 degrees (less than 1/4 turn) until it
"bottoms out" (does not turn any further). The screw
does not take much pressure to turn. Stop when the
screw does not easily turn any further. Repeat for each
valve until all have been adjusted correctly.
Replace the knobs.
5.
" (39 mm)
^
9